排汙泵因為作業環境相對惡劣複雜，若不注重日常養護，各類異常故障的發生概率相較其他泵類產品要高，發生鏽蝕的排汙泵往往開機困難，無法正常完成輸運工作。

像這種情況隻能通過拆泵後替換鏽蝕嚴重的部件來恢複使用，而且發生鏽蝕的部件如果十分嚴重，出現卡死情況，拆卸起來就會困難許多，可以通過加熱的方式來降低拆卸難度，配合木錘敲擊和一字螺絲刀進行撬，盡量避免硬拉，以防損壞泵體。根據實際鏽蝕情況，還可考慮在鏽蝕的間隙中滴入潤滑油浸透片刻，可以進一步降低拆卸難度。

從以往的排汙泵使用經驗來看，通常是使用完畢後不排除積水，或者長時間存放在潮濕中導致的鏽蝕。不鏽鋼排汙泵並非不會生鏽，隻是相對於一般的鋼鐵而言，所能適應的環境更為廣泛，但若存放或者日常保養不當，依然是有可能會生鏽的。

在停用排汙泵後及時排進泵內積液，如果一定時間內不會再使用，則盡量存放在清潔通風的環境中；

長時間不用的排汙泵不要直接放置於液下不管，應當及時收納後儲存，減少電機受潮的機會，同時也減少受到鏽蝕的概率；

定期檢查排汙泵的運行參數和各個組件的完好性，可有效預防異常工況的出現。

Due to the relatively harsh and complex working environment of the sewage pump, if we do not pay attention to daily maintenance, the probability of various abnormal faults is higher than that of other pump products. The rusted sewage pump is often difficult to start and cannot complete the transportation work normally.

In this case, it can only be restored to use by replacing the severely rusted parts after dismantling the pump. If the rusted parts are very serious and get stuck, it will be much more difficult to disassemble. The difficulty of disassembly can be reduced by heating. It can be pried with a wooden hammer and a slotted screwdriver to avoid hard pulling as far as possible to prevent damage to the pump body. According to the actual corrosion situation, it can also be considered to drip lubricating oil into the corrosion gap and soak it for a moment, which can further reduce the difficulty of disassembly.

From the previous experience of using sewage pumps, it is usually caused by not removing ponding after use, or corrosion caused by storing in humidity for a long time. Stainless steel sewage pump is not free from rust, but it can adapt to a wider environment than ordinary steel, but it is still likely to rust if it is stored or maintained improperly.

After stopping the sewage pump, drain the accumulated liquid into the pump in time. If it will not be used for a certain period of time, store it in a clean and ventilated environment as far as possible;

Sewage pumps that have not been used for a long time should not be placed directly under the liquid. They should be stored after being stored in time to reduce the chance of the motor getting damp and the probability of corrosion at the same time;

Regularly check the operating parameters of the sewage pump and the integrity of each component, which can effectively prevent the occurrence of abnormal working conditions.

高揚程汙水泵